DJI POWER 1000/2000 Fastener Bracket

The DJI Power Fastener Bracket locks a DJI Power 1000, DJI Power 1000 V2 or DJI Power 2000 portable power station down so it stays put. The bracket screws into the two threaded points low on the end of the power station, then screws down to whatever you want it to live on. A car boot, a van floor, a 4WD drawer system, a camper, a boat, a DIT cart, a workshop bench. Where you fix it is up to you.

It is one of our most popular parts right now, and it is simple for a good reason. A power station that weighs as much as a DJI Power does not want to be loose in the back of a car.

COMPATIBLE WITH

• DJI Power 1000 (the original, Mark 1)
• DJI Power 1000 V2 (Mark 2)
• DJI Power 2000

MADE FOR THE BACK OF A VEHICLE

A typical setup in a vehicle: the bracket holds the DJI Power station to a storage box in the back of the car.

Most people put this in a vehicle. In the photo above, a DJI Power station sits on a carpeted steel storage box in the back of a car, beside a fridge. The bracket is screwed into the end of the power station and down into the platform, so the unit cannot slide forward under braking or walk around on rough roads. It is the kind of setup you see in overlanding and camping builds, van conversions and film production vehicles, where the power station runs the fridge, charges camera batteries or keeps a laptop alive all day.

It works just as well off the road. Fix it to a camera cart or DIT cart so the power station does not shift when the cart is pushed across a set, or to a shelf in a studio or workshop.

SINGLE OR PAIR

One bracket holds one end of the power station. That is enough to stop it sliding on a flat surface. For a vehicle, get the pair and put one on each end so the unit is held from both sides.

WHAT IS IN THE BAG

Per bracket:

• 1 x fastener bracket
• 2 x 1/4"-20 socket head screws, to fix the bracket to the power station
• 2 x surface screws, around 40 mm long, to fix the bracket down

The pair comes with double the hardware.

A NOTE ON THE SURFACE SCREWS

We include surface screws so you can fit the bracket straight away, but they are around 40 mm long and they will not suit every job. Thin sheet metal, a ply floor and a thick timber bench all need a different screw. Your application may need a shorter or a longer one, so check what you are fixing into and pick up the right screw from the hardware shop if ours are wrong for it. If you are going through a vehicle floor, check what is underneath before you drill.

PRINTED STRONG

We print these ourselves in our workshop and we print them strong, in glass fibre reinforced ABS. It stays rigid and it does not soften in a hot car the way PLA would. The bracket has a solid base plate and a centre rib that takes the load when the power station tries to tip. Once it is on, it is the part of your setup you stop thinking about.

QUICK ANSWERS

Does it fit the DJI Power 1000 V2? Yes. It fits the original DJI Power 1000 (Mark 1), the DJI Power 1000 V2 (Mark 2) and the DJI Power 2000.

Do I need to drill the power station? No. The bracket uses the threaded points that are already on the end of the unit.

Can I mount it in my car? Yes, that is what most people use it for. Screw it into a platform, drawer system or floor in the back of the vehicle, and use the pair so both ends are held.